Push / Pull Heater Control Cable & Knob 1.0m Stepped End
£23.00
£23.00
In stock
P/N
37E-F13-63D
Push / Pull Heater Control Bowden Cable & Knob 1.0m with Stepped End
A high-quality Heater Control Cable & Knob to operate Bowden controlled heater valves, the internal cable is solid and works in both push or pull directions. Cable can be cut and trimmed to length if required but you would need to form a new step on the end should you wish to shorten the valve.
Manufactured to a high standard in the UK.
| Specification | Metric | Imperial & Other |
| Minimum Temperature | -20 °C | -4 °F |
| Maximum Temperature | 80 °C | 176 °F |
| Cable Length | 1 m | 3.3 ft |
| Cable Travel | 50 mm | 2" |
| Knob Diameter | 22 mm | 7/8" |
| Panel Hole Size | 10 mm | 3/8" |
| Cable Diameter | 1.6 mm | 0.06" |
| Behind Dash Clearance Req'd | 250 mm | 10" |
| Cable End | Stepped | |
| Part Number | 37E-F13-63D | |
ATTENTION
- We offer these with looped and stepped ends. Please double check you are ordering the correct version prior to checkout.
- Please note that is a non-locking type control knob.
| Water Control Type | Switch |
|---|---|
| Manufacturer | T7Design |
Write Your Own Review