Phillips & Temro Wolverine PAD Electric Battery Heater 5.5 x 8.5" 60w 230v

3400096 Wolverine Silicone PAD Electric Battery Heater 5.5 x 8.5" 60w 230v

A silicone heating pad placed underneath the batteries maximizes performance, efficiency and reliability in cold-weather starting and charging.

Operating in extreme conditions requires dependable solutions. Give your engine the help it needs to start in the coldest weather by installing silicone pad heaters. These heaters are designed to provide warmth to areas with fluid susceptible to freezing or thickening. Electric heating pads are designed to be applied directly to the source, resulting in direct heat transfer. They are a low wattage, energy efficient solution.

Two wires (same color) should be connected to the power source (or temperature control device) directly, through a junction box, or to a connector that is mated to a receptacle connected to the power source. Wolverine Heating PADS/Blankets are non-polarized, allowing either wire to be connected to the neutral or live. The third wire (if applicable), designated by the color green (or a green stripe), should be connected to ground.

IMPORTANT: If installing any 230v component to your vehicle please ensure the vehicle chassis and component are correctly earthed to the Green (or Yellow/Green stripped) plug wire to prevent potential for electric shock and injury.

The Silicone PAD Heater kit comes with the following components:

ATTENTION

• Please double check dimensions and voltage are suitable for your application prior to checkout.
• Do not cut down or trim heater pad.
• Fully read instructions prior to installation.